MATLAB Answers

Jose

simulink and guide interface

Asked by Jose
on 27 Jul 2012
Latest activity Commented on by Jesus Gerardo
on 13 May 2015 at 17:03
Accepted Answer by TAB

Hi, everyone. I want to know how i do a interface with guide and simulink. well i want to watch in a interface a graphic of a block output (like a scope), and 3 values of another blocks. I know how i can run an stop the simulink and i saw a document were they change parameters of blocks, but i just want to watch. thank you for your answers..

  1 Comment

Jesus Gerardo
on 13 May 2015 at 17:03

how are you jose you can put the link of the document that you saw, where the parameters change

Products

1 Answer

TAB
Answer by TAB
on 27 Jul 2012
Edited by TAB
on 27 Jul 2012
 Accepted answer

You can save the simulation data to base workspace using To Wokspace block and plot it using matlab command after simulation is completed.

----OR----

You can plot the simulink data at run time when simulation is running using event listener.

Go through this similar post for links to detailed help and examples.

  2 Comments

Jose
on 27 Jul 2012

thanks!!

Jesus Gerardo
on 13 May 2015 at 17:03

how are you jose you can put the link of the document that you saw, where the parameters change


Discover what MATLAB® can do for your career.

Opportunities for recent engineering grads.

Apply today