Simscape / Electrical / Control / General Control
The On-Off Delay block applies a delay on the Boolean input signal.
A time delay is added when a transition is detected in the input signal. This block allows you to add a time delay to the input signal when:
An ON transition (input change from 0 to 1) is detected,
An OFF transition (input signal change from 1 to 0) is detected, or
Either transition is detected.
The operation of the on-off delay is represented in the following figure:
u— Input signal
Input Boolean signal.
y— Output signal
Output signal with delays.
ON delay time (s)— Input ON delay time
0| positive scalar
Specify delay time when input is ON.
OFF delay time (s)— Input OFF delay time
0(default) | positive scalar
Specify delay time when input is OFF.
Initial state— Signal initial state
Specify initial state.
Sample time— Block sample time
0.001(default) | 0 | positive scalar
Time between consecutive block executions. During execution, the block produces outputs and, if appropriate, updates its internal state. For more information, see What Is Sample Time? (Simulink) and Specify Sample Time (Simulink).
For discrete-time operation, set the sample time to a positive value. For
continuous-time operation, set the sample time to
If this block is in a masked subsystem, or other variant subsystem that allows either continuous and discrete operation, promote the sample time parameter. Promoting the sample time parameter ensures correct switching between the continuous and discrete implementations of the block. For more information, see Promote Parameter to Mask (Simulink).