SCI
To set SCI parameters, use the SCI options. The pins in the SCI0(default) option are the Arduino® header pins mentioned in https://os.mbed.com/platforms/ for the selected Nucleo board.
Baudrate (in Hz)
Specify the baud for SCI communication.
Settings
Default:
115200
Receive pin
Specify a receiving pin of UART.
Transmit pin
Specify a transmitting pin of UART.
Data bits length
The number of data bits to transmit in a packet.
Note
This parameter appears dimmed.
Settings
Default:
8
Parity
Select the type of parity checking for SCI communication
Settings
Default:
None
Even, Odd
None — No parity checking
Even — Even parity checking
Odd — Odd parity checking
Stop bits
Select the number of Stop bits used to indicate end of a packet.
Settings
Default:
1
0.5, 1.5, 2
0.5
— The stop bit is transferred for 50% of the normal time used to transfer 1 bit.1
— One stop bit is transmitted to indicate the end of a byte.1.5
— The stop bit is transferred for 150% of the normal time used to transfer 1 bit.2
— Two stop bits are transmitted to indicate the end of a byte.