Increment output signal by 1 with every time step
Simscape / Foundation Library / Physical Signals / Sources
The PS Counter block increments the output signal, Y, by 1 with every time step repeatedly between the minimum (reset) value and the maximum value. You can optionally specify an initial signal value, different from the reset value, and an initial time offset. The output signal generated by the block is shown in the following diagram.
If the initial time offset is specified, the block outputs the initial signal value
init until the simulation time reaches the
offset value, at which point the counting cycle starts. The block
outputs the current value for one time step, then repeatedly increments the signal value by 1
and outputs it for one time step, until it reaches the maximum value
max. The block outputs the
for one time step, then returns to the
reset value, and the
counting cycle starts again.
Use this block, in conjunction with other physical signal blocks, to model discrete behaviors.
The Discrete-Time PWM Voltage Source example illustrates how you can use the PS Counter block to build components with more complex behaviors. For an alternative asynchronous implementation, see the Asynchronous PWM Voltage Source example. The discrete-time version is better suited to fixed-step solvers and hardware-in-the-loop applications, whereas the asynchronous implementation is better suited to fast desktop simulation using variable-step solvers.
Y — Output physical signal, unitless
Output physical signal.
Sample time — Sample time interval
1 s (default)
The value and unit of the time
step interval. The default
step value is
1 s. To specify an initial
time offset, enter the parameter value as
[ , otherwise the
offset value is assumed to be
Initial value — Output at time zero
The value of the output signal at the beginning of the first counting cycle. If you
specify an initial time offset by using the Sample time parameter,
the output of the block remains at this value until the simulation time reaches the
offset value, after which the first counting cycle starts.
The value must be an integer.
Reset value — Minimum output
The value of the output signal at the beginning of each counting cycle except the
first one. The output of the block remains at this value for one time
step, specified by the Sample time
parameter. The value must be an integer.
Maximum value — Maximum output
The value of the output signal at the end of the counting cycle. The output of the
block remains at this value for one time
step, specified by
the Sample time parameter, at which point the signal returns to the
Reset value and the cycle starts again. The value must be an
integer. The default value is
intmax (2147483647, the largest
positive value that can be represented in the MATLAB® software with a 32-bit integer).
C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.
Version HistoryIntroduced in R2012b
R2019a: Unit Propagation
Prior to R2019a, this block did not propagate physical units.
If your model contains legacy blocks without unit propagation, use the Upgrade Advisor to upgrade your blocks to the latest version. For more information, see Upgrading Models with Legacy Physical Signal Blocks.