Set shaft speed of continuous rotation servo motor
Simulink Support Package for Arduino® Hardware/Common
Set the direction and speed of a continuous rotation servo motor:
Sending -90 to the block input produces the maximum rate of rotation in one direction.
90 to the block input produces the
maximum rate of rotation in the opposite direction.
Sending 0 to the block input stops the servo motor.
Sending out-of-range values, such as
200, to the block input has the same effect
as sending the minimum or maximum input values.
The characteristics of some motors cause them to continue rotating when the block input value is 0. In that case, you can experiment to find an offset value that stops the motor.
With Arduino Mega 2560 hardware, you can use External mode to determine the offset while your model is running on the hardware. See Tune and Monitor Model Running on Hardware.
The block input inherits the data type of the upstream block, and internally converts it to uint8 with an offset of 90.
During simulations without the hardware, this block does nothing.
If you use this block in models with the Serial Receive and Serial Transmit blocks, use longer sample times to avoid overruns.
The maximum number of Servo blocks per model is 12 for most Arduino boards except for Arduino Mega 2560, Arduino Mega ADK hardware where the maximum is 48.
With Arduino Uno, Nano, hardware, the Arduino PWM block cannot use digital pins 9 or 10 when the model contains Servo blocks.
With Arduino Mega 2560, Mega ADK hardware, the Arduino PWM block cannot use digital pins 11 or 12 when the model contains more than 12 Servo blocks.
With Arduino Due hardware, the Arduino PWM block cannot use digital pins 9 or 10 when the model contains Servo blocks.
Enter the number of the digital pin.
Do not assign the same pin number for different types of blocks as this may cause resource management conflicts.
Click View pin map to open the Arduino Pin Mapping table .
To know how to assign pins or to know about the fixed pins for the blocks, see the Arduino Pin Mapping for Timer Dependent Blocks.