You can use processor-in-the-loop (PIL) executions to verify generated code that you deploy to target hardware by using a MATLAB® Coder™ procedure. You can profile algorithm performance and speed of your generated code on the target hardware. To verify generated code with the MATLAB Coder app, you must have MATLAB Coder and an Embedded Coder® license.
This PIL execution is also available with these hardware support packages.
Embedded Coder Support Package for BeagleBone® Black Hardware
Embedded Coder Support Package for ARM® Cortex®-A Processors
Embedded Coder Support Package for STMicroelectronics® Discovery Boards
You can set up PIL execution with the MATLAB Coder app.
To open the MATLAB Coder app, see Open the MATLAB Coder App and Select Source Files.
To configure the build type and hardware board:
On the Generate Code page, in the Generate dialog box:
Set the Build type to
Clear the Generate code only check box.
Set the Hardware Board to
If necessary, modify the settings for your board. To modify the settings, click Settings > All Settings, and then click Hardware.
Specify the stack usage of the generated code in the Memory > Stack usage max parameter. The memory of the hardware board is
limited, and a default value of
beyond the stack size available in the hardware. We
recommend you to set the value to
However, specify an appropriate stack size based on your
To generate the library, click Generate.
Set up your PIL execution. To open the Verify Code dialog box, click Verify Code.
Because the hardware board is not
Computer, the Verify
Code dialog box is configured for PIL
In the Verify Code dialog box:
Enter the name of the test file to use for PIL execution.
Select Generated code.
To start the PIL execution, click Run Generated Code.
To stop the PIL execution, click Stop.
To install the Embedded Coder Support Package for ARM Cortex-M Processors, see Embedded Coder Supported Hardware.