How can i add engine rpm as a step input for Mass Spring Damper model

i need to add Engine rpm as the step input here in this model , how can i achieve that

Thanks a lot in advance

Answer 1

[Vinay]

Hii Andrew,

The issue occurs because the ‘step’ block in the circuit is not from the Simscape Electrical library but from the Simulink library.

You can use the 'Simulink -PS Converter' block to connect Simulink block to a Simscape physical network.

You can refer to the following documentation for ‘Simulink-PS converter’:

https://www.mathworks.com/help/simscape/ref/simulinkpsconverter.html

I have attached an image showing the step signal connection below

I hope this helps!