Mux to Bus error message
22 views (last 30 days)
Show older comments
I'm getting a strange error when trying to run one of our models in simulink: I'm being told 'The block diagram 'Filename' uses bus signals. However, the 'Mux blocks used to create bus signals' diagnostic is not configured to 'error'. To prevent modeling errors:'
Why am I getting an error message for something I've deliberately turned off? Due to the way the model interfaces with our software it has to have a mux creating a bus otherwise it won't work so I can't replace the muxes with buses.
1 Comment
Kevin Quigley
on 16 May 2017
You accepted the answer, but it's unclear if using the suggested setting solved your problem or it prevented you from using your model as implied in your question.
What was the outcome of setting this to 'error'? Did you have to rework the model?
Accepted Answer
Vinod Sudheesh
on 27 May 2015
Hi Matthew,
To avoid this error please navigate to
Model Configuration Parameters (Ctrl+E) >> Diagnostics >> Connectivity >> Mux blocks used to create bus signals:
and set the value to "error".
Please note that this diagnostic needs to be set to "error" whenever there is a bus signal in the Simulink model so as to ensure that there will not be any problems with block connections while compiling the model.
Hope this helps!
Vinod
9 Comments
More Answers (1)
See Also
Categories
Find more on Data Types in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!