Syntax Error with Fcn Block in Simulink

Hello,

I am working on a model for a BLDC motor. I am using the Fcn block for my inputs in the current generation subsystem. I seem to be getting a syntax error when I run the simulation. Any help is appreciated.

Best,

Samuel

Answer 1

[Jonas]

Are you sure the input of the function block has a signal dimension of 6?

[Samuel Gottesfeld]

Yeah, there should be 6

[Jonas]

Could you upload the subsystem as displayed on your screenshot?

[Samuel Gottesfeld]

Thank you for your patience regarding my reply. It was near 2:30 am when i posted this question, and I fell asleep. Posted is the complete subsystem for the current generation.

Capture1 is inside of the subsystem in capture3; then capture4 has the subsystem in capture3. Capture5 is the complete model of the BLDC motor.