IF-ELSE block in simulink
Show older comments
Assalamualaikum & hi all
I just want to know is it possible to end the IF-ELSE block execution process at certain point. Because in my model the IF_ELSE block keeps execute,unless i stop the model. My model run in real-time process using Wincon software
Accepted Answer
Kaustubha Govind
on 3 Nov 2011
0 votes
You can put the If-Else subsystem inside an Enabled Subsystem that you can disable/enable at any point in the simulation.
5 Comments
Mohd Hazny Aziz
on 4 Nov 2011
Kaustubha Govind
on 4 Nov 2011
I suppose you meant to say "the if-else subsystem will *NOT* execute until it is enabled"? Yes, that's correct.
Mohd Hazny Aziz
on 9 Nov 2011
Kaustubha Govind
on 9 Nov 2011
Yes, the enabled subsystem will also look at the control signal at every time-step. If the control signal disables it, it will not run the contents of the subsystem.
Mohd Hazny Aziz
on 11 Nov 2011
More Answers (0)
on 3 Nov 2011
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!