Accept all messages (in FIFO 0)
Allow all CAN messages in FIFO 0
Since R2024b
Model Configuration Pane: Hardware Implementation / Simulink or Embedded Coder Hardware Support Package / Hardware board settings / Target hardware resources / CAN
Description
Enable this parameter to allow all CAN messages in FIFO 0. If it is disabled, then you can select and allow only the required CAN messages.
Settings
off
|
on
Enable this parameter to allow all CAN messages in FIFO 0. If it is disabled, then you can select and allow only the required CAN messages.
Recommended Settings
No recommendation.
Programmatic Use
No programmatic use is available. |
Version History
Introduced in R2024b