Transmission Control Protocol (TCP) is a transport protocol layered on top of the Internet Protocol (IP) and is one of the most highly used networking protocols. You can use network socket communication to connect to remote hosts to read and write data.
If you are having trouble connecting to or communicating with your remote host, try these troubleshooting tips.
TCP/IP is supported on these platforms:
The TCP/IP client interface is supported on the same platforms as MATLAB®. For updates to the list of currently supported platforms, see System Requirements.
Make sure you can create your TCP/IP client object. You create a client
object with the
tcpclient function, which requires the
name of the remote host as an input argument. You also need to specify the
remote port value.
Each client object is associated with one instrument. For example, to create a client object for a Sony/Tektronix® AWG520 Arbitrary Waveform Generator, you use the remote host name of the instrument and the port number, which can be found in the instrument documentation.
t = tcpclient("sonytekawg.yourdomain.com",4000);
After you connect to the device, you can communicate with it. If sending and receiving does not work, you can check the following:
Make sure the data is being sent in the format expected by the server.
If you connect to a web server, you might need to send HTTP
post commands. You
can also use the
webread functions to communicate with web
Many TCP/IP servers expect header information inside the TCP/IP packet.
See Write and Read Data over TCP/IP Interface for an example of communication over TCP/IP.
You can also use the
visadev interface with a VISA-TCP/IP
resource name instead of the
tcpclient interface for TCP/IP
communication with instruments.
Make sure the correct data type—for example
double—is being used with
write. Use the same data type as
the instrument. If reading and writing data types other than
int8, make sure the
ByteOrder is correct.