Debug on Linux Platforms
The GNU® Debugger gdb, available on Linux® systems, provides complete source code debugging, including the ability to set breakpoints, examine variables, and step through the source code line-by-line.
In this procedure, the MATLAB® command prompt
>> is shown in front of
MATLAB commands, and
linux> represents a Linux prompt; your system might show a different prompt. The debugger prompt is
This example shows the general steps to debug
yprime.c, found in
To debug with gdb:
Compile the source MEX file with the
-goption, which builds the file with debugging symbols included. For this example, at the Linux prompt, type:
linux> mex -g yprime.c
At the Linux prompt, start the gdb debugger using the
linux> matlab -Dgdb
Tell gdb to stop for debugging.
<gdb> handle SIGSEGV SIGBUS nostop noprint <gdb> handle SIGUSR1 stop print
Start MATLAB without the Java® Virtual Machine (JVM™) by using the
<gdb> run -nojvm
In MATLAB, enable debugging with the
dbmexfunction and run your binary MEX file.
>> dbmex on >> yprime(1,1:4)
You are ready to start debugging.
It is often convenient to set a breakpoint at
mexFunctionso you stop at the beginning of the gateway routine.
<gdb> break mexFunction <gdb> r
Once you hit one of your breakpoints, you can make full use of any commands the debugger provides to examine variables, display memory, or inspect registers.
To proceed from a breakpoint, type:
After stopping at the last breakpoint, type:
yprimefinishes and MATLAB displays:
ans = 2.0000 8.9685 4.0000 -1.0947
From the MATLAB prompt you can return control to the debugger by typing:
>> dbmex stop
Or, if you are finished running MATLAB, type:
When you are finished with the debugger, type:
You return to the Linux prompt.
Refer to the documentation provided with your debugger for more information on its use.