Two-port inertia in mechanical rotational systems
Mechanical Rotational Elements
The Rotational Inerter block represents a device that has torque proportional to the rate of change of the relative angular velocity across the ports. It is essentially a two-port inertia that works on the velocity difference between the ports, not the absolute velocity.
Use this block in high performance suspension systems, to decouple weave and roll modes, or in applications where you need to model a passively tuned mass-spring-damper response.
The block is described with the following equations:
|T||Torque transmitted through the inerter|
|ω||Relative angular velocity|
|ωR, ωC||Absolute angular velocities at ports R and C, respectively|
The block positive direction is from port R to port C. This means that the torque is positive if it acts in the direction from R to C.
To set the priority and initial target values for the block variables prior to simulation, use the Initial Targets section in the block dialog box or Property Inspector. For more information, see Set Priority and Initial Target for Block Variables.
Nominal values provide a way to specify the expected magnitude of a variable in a model. Using system scaling based on nominal values increases the simulation robustness. Nominal values can come from different sources, one of which is the Nominal Values section in the block dialog box or Property Inspector. For more information, see Modify Nominal Values for a Block Variable.
- Rotational inertance
Proportionality coefficient between the torque and the rate of change of the relative angular velocity across the ports. The default value is
The block has the following ports:
Mechanical rotational conserving port associated with the rod.
Mechanical rotational conserving port associated with the case.
C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.
Introduced in R2015b