Simulink Switch Outputs wrong data format
1 view (last 30 days)
Show older comments
Florian Rössing
on 24 Sep 2021
Commented: Florian Rössing
on 24 Sep 2021
Hi everyone.
I am currently experiencing problems with the switch block.
I havebuild a basic edge detector:
My Problem now is, that the output of out.TDCValid is a Nx1 Array, but out.TDCValid1 outputs 1x1xN instead the expected Nx1. I cannot figure out why this is. Any Ideas from your side?
0 Comments
Accepted Answer
Fangjun Jiang
on 24 Sep 2021
check the size/dimension of the Constant zero block, the "TriggerOUT" Outport block and the Switch block itself. Specify it as [1], not [1 1].
If nothing else, run squeeze(out.TDCValid1)
More Answers (0)
See Also
Categories
Find more on Sources in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!