Disable code generation while runnign the simulation of a model

I need to disable the code generation while running the simulation. I am using the below code with the parameters

    set_param(TestModelName, 'SimulationMode', 'Software-in-the-Loop (SIL)');
    set_param(TestModelName, 'GenCodeOnly', 'off');
    sim(TestModelName)

But even then the code is generated. Any idea what else I can do to not generate the code.

Answer 1

[Orion]

If you want to simulate in SIL mode, SImulink will generate some code.

if you don't want any code generation, you need to set 'SimulationMode' to normal.

Note that if there are some stateflows in your model, some code will still be generating.

[Sandeep]

Agreed, on normal mode it wont generate any code. But my requirement is to run in SIL mode but not to generate any code. I want to use the previously generated code hence. This will also save considerably lot of time when I run for 98 models.