Observer Port error: Observer Port is mapped to an invalid block, because this block is inside a function-call subsystem.
13 views (last 30 days)
Show older comments
Hello,
I'm testing the Simulink model at the component level by using Simulink test. I need to verify some internal signals. In this way I tried to use the Observer Reference Block and Observer Ports. I followed the steps from the link: Access Model Data Wirelessly by Using Observers - MATLAB & Simulink (mathworks.com).
I get the following error:
Observer Port is mapped to an invalid block, because this block is inside a function-call subsystem.
I was wondering if this is a tool limitation or is it somethig that I am doing wrong?
I appreciate a lot your support! Thank you very much!
Diana
3 Comments
Accepted Answer
Varun
on 27 Feb 2024
Hi Diana! As per the following documentation link (https://www.mathworks.com/help/sltest/ug/access-model-data-wirelessly-by-using-observers.html), the "Observer Port" block can observe the following signals:
- Continuous-time and Discrete-time signals
- Zero-order hold signals
- Scalar signals
- Wide signals
- Nonvirtual bus signals
- Messages
- Conditional subsystem signals
- Stateflow® local data parameters, except locals, parameters, signals, and other data defined in a Simulink subsystem inside a Stateflow state.
- Stateflow state self activity, except if that activity is in a Simulink subsystem inside a Stateflow state.
So, it appears that a function-call subsystem is probably not supported yet. But to achieve similar results, you can propagate and log the signal outside the function-call subsystem using a "Data store" block.
You can refer to the following documentation link to learn more: https://www.mathworks.com/help/simulink/ug/data-store-basics.html.
Hope this helps!
0 Comments
More Answers (0)
See Also
Categories
Find more on Inputs in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!