Can I create a series of signals continuously over a period of time using 5g toolbox?

I am working on a project, where I need to simulate and generate 5g signals continuously over a period of time and then analyze the generated signals periodically. At this moment I can generate one 5g signal using the 5g toolbox 5g waveform generator tool or using the function nrWaveformGenerator. But, I need to generate the 5g signal over a period of time continusly. How can I acheive that?

Thanks in advance

P.S: I am a beginner to networking, I might miss some point explaining the question.

Answer 1

[Asim]

Hello Madhurjya,

To simulate continuous 5G signal generation in MATLAB, you can use a loop to repeatedly call the nrWaveformGenerator function. Here's a concise guide:

1. Set simulation parameters: Choose your simulation duration and signal parameters (e.g., subcarrier spacing, bandwidth).
2. Initialize configurations: Before the loop, set up your carrier, UE, and channel configurations.
3. Implement a loop: Use a loop to generate waveforms at each time step for the entire simulation duration.
4. Generate and process waveforms: Inside the loop, call nrWaveformGenerator to create your signal, then analyze or store it as needed.
5. Post-processing: After the loop, perform any final analysis on the collected data.

Here is a pseudo code for your reference:

% Define simulation duration and time step
simulationDuration = 10; % seconds
timeStep = 1e-3; % seconds
numSteps = simulationDuration / timeStep;

% Initialize 5G configurations
% ...

% Simulation loop
for step = 1:numSteps
    % Generate the 5G waveform
    [waveform, ~, ~] = nrWaveformGenerator(...); // Remember to replace ... with your actual parameters

    % Analyze or store the waveform
    % ...
end

% Post-process the data
% ...

I hope it helps.

Best Regards,

Asim Asrar