The FIND block in Simulink is fixed size, but labeled as variable

I pass the vector [0; 0; 2; 0; 0; 2; 0; 0] (8x1) into the FIND block in Simulink. According to the documentation, the output should be the indices of the non-zero elements in the vector. This, by definition, would be a variable size, and the output is shown as variable size (thick dashed line instead of thin solid line). However, the size is 8 and not 2 as I expect it. The output is padded with 0's, so it is [3; 6; 0; 0; 0; 0; 0; 0].

The next step in my simulation is to pass it into an Embedded Matlab script. I configure the input port to be variable size, but when I run it, I get the error "Data is inferred as a variable size matrix, while its specified type is something else."

I tried using a selector block to pick out the first 2 values, but the output is exactly the same - variable size and padded with zeros.

Any advice on how to get the output of FIND into an EML script in Simulink successfully?

Answer 1

[Kaustubha Govind]

The error that you get is "Data is inferred as a variable size matrix, while its specified type is something else." - which means that the block is able to infer that the input of of variable-size (which is correct), but you are specify it as a fixed-size signal. You can configure this setting by opening up the Embedded MATLAB Editor, then, select Tools>Edit Data/Ports. Select the corresponding input and check "Variable-size" on the right panel. Also, enter [8 1] as the Size (this is used as the maximum size for variable-size signals).

[Amy Cutting]

Thanks. I had the "Variable-size" checked already, but I had not specified the size. That did the trick.