Sending a 2MHz Baseband Signal using USRP and Simulink Block?
1 view (last 30 days)
Show older comments
Matt Curtis on 6 Jun 2017
Answered: Arnav Mendiratta on 13 Jun 2017
What are the maximum frequency restraints for transmitting a complex sine wave using the SDRu TX/RX blocks in Simulink for USRP? I am trying to send a 2MHz sine wave but is distorted on the RX side. I am setting my sampling rate in the sin wave block and TX/RX blocks to uphold the Nyquist sampling theorem. I am using the USRP N210 and WBX-40 daughtercard.
Arnav Mendiratta on 13 Jun 2017
These blocks should be able to support frequencies in GHz range. Without your model, it's hard to figure out what the issue might be. Make sure you take care of your design as mentioned in the following discussion:
If you are still facing issue, contact the engineers at MathWorks Technical Support .
Find more on Communications Toolbox in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!Start Hunting!