How do I know the eCAN Transmit transfer rate and how do I change it?
1 view (last 30 days)
Show older comments
Hello everyone, I am using TI DSP TMS320 F28335 to communicate with Matlab via CAN-bus. I use the Embedded Coder Support Package for Texas Instruments C2000 Processors/C2833x to build the transmit model for my DSP. The communication all works fine but how do I know what the transfer rate is? And how do I change it? and how faster can it go? How do I know its limit?
Because I have a motor control that has the resolution of 10 µs. And I want the DSP to upload the value from the motor control to the DSP. The problem is I dont know the transfer rate of the eCAN Transmit. If the transfer rate is 100µs(What I assume), then I want to make it much smaller. I hope someone can help me with this.
1 Comment
shivam chaturvedi
on 6 Aug 2019
How did you connect the transceiver with the can bus can you please share.
Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!