Gaussian fit to xy data and extracting FWHM
328 views (last 30 days)
Show older comments
Hello,
I am hoping someone could help. I am going round in circles although i'm sure it's a straightforward answer.
I have an xy data set (see attached for example). I want to fit a gaussian to this, from which the FWHM of the gaussian and the goodness of fit extracted (those that do not have good gaussian fits will be then rejected on the basis of r squared values.
I tried using cftool, and from what i have read, I can use FWHM= 2*sqrt(2*log(2))*c1 to get the FWHM. But the value I get (~30), doesn't match up to what i expect from looking at the curve at the half-maximum (~20).
Thankyou
0 Comments
Accepted Answer
Daniel M
on 8 Jan 2020
This is because of the slightly different way cftool has defined the gaussian equation for the fit, and it ends up multipling the c1 coefficient by a factor of sqrt(2) from the true value of the standard deviation.
The equation for FWHM is
FWHM = 2*sqrt(2*log(2))*sigma
%%% sigma, NOT c1!
For fitting, MATLAB uses
f(x) = a1*exp(-((x-b1)/c1)^2)
And wherever you're reading the FWHM equation defined the gaussian as
f(x) = (1/sigma/sqrt(2*pi))*exp(-(x-mu)^2/(2*sigma^2))
By equating the two, you'll find that
sigma = c1/sqrt(2)
Therefore the FWHM equation becomes
FWHM = 2*sqrt(2*log(2)) * (c1/sqrt(2))
FWHM = 2*sqrt(log(2)) * c1
And in fact, when you use this new equation, you get FWHM = 21.78, which is accurate.
More Answers (1)
Fynn Reinbacher
on 5 Nov 2020
You can also obtain σ from a.
However one has to be careful.
More on that here:
0 Comments
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!