How can I access the value of signals at the time of stopping the simulation.

I want to update the initial values of signals(Simulink.Signal) to the values that these signals hold at the time of stopping the simulation.

All the signals that I use are defined in Matlab workspace.

Answer 1

[Azzi Abdelmalek]

Don't stop your simulation, just pause it

set_param('yourmodel','SimulationCommand','pause')

To continue simulation

set_param('model','SimulationCommand','continue')

[Kushagra]

I need to stop and simulate model again because after updating values, I want default transitions in stateflow to be executed again. If I pause and then continue the simulation, stateflows will maintain their present state (Once stateflow flow is activated, it can go in sleep but cannot become inactive in that simulation).

Answer 2

[Kaustubha Govind]

Perhaps you can use the model callback StopFcn to update the workspace using simple MATLAB code?

[Kushagra]

Actually I am not able to access the values of those signals through code. Could you please help me with that.

[TAB]

Can you post the code you have are using ?