How can i get eigen values from simulink model

45 views (last 30 days)
i made my simulink model and run it in steady state and find initial operating state.i want to find eigen values around this operating point.further if i create small perturbation in system,how can i get eigen value after perturbation. please suggest me
  1 Comment
Kaustubha Govind
Kaustubha Govind on 5 Feb 2013
Krishan: Please avoid repeating the same question again. You have already asked a similar question at http://www.mathworks.com/matlabcentral/answers/62258-how-can-i-get-eigenvalues-from-my-simulink-model-after-small-perturbation. It is best to continue related discussions on the same thread.

Sign in to comment.

Answers (2)

Ryan G
Ryan G on 5 Feb 2013
You can use the linear analysis tool to first find the operating point (using operating point snapshot). Then you can linearize the model around this operating point. From here you can find the A matrix from the result and use the EIG function.
  1 Comment
SinanB
SinanB on 11 Jul 2017
I tried this but Eig(linsys1.A) don't give the expected poles (indicated in the power_PSS example such as 0.64Hz, 1.12Hz and 1.16 Hz). Please note that for the related modes, damping is so small that natural frequencies are approximately the same as the complex part of the poles.
Note that the eigenvalues can also be obtained by damp(linsys1).

Sign in to comment.


SinanB
SinanB on 7 Jul 2017
I tried this but Eig(linsys1.A) don't give the expected poles (indicated in the power_PSS example such as 0.64Hz, 1.12Hz and 1.16 Hz). Please note that for the related modes, damping is so small that natural frequencies are approximately the same as the complex part of the poles.
Note that the eigenvalues can also be obtained by damp(linsys1).

Categories

Find more on Trimming and Linearization in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!