Need half of my contour plot

10 views (last 30 days)
Maryam
Maryam on 18 Jul 2013
Hello I have a contour of the pressures over a surface. Basically, I had vectors x and y which were locations on the surface and on each location, I had a value for pressure. I have a rectangular plot. I was wondering if there is a way to split my plot from the diagonal and show just the results for either upper or lower triangles?

Accepted Answer

Kye Taylor
Kye Taylor on 18 Jul 2013
Edited: Kye Taylor on 18 Jul 2013
Check out the tril and triu functions. For example if you have data similar to
[x,y]= meshgrid(-1:.05:1);
z = x.^2+y.^2;
contour(x,y,z)
Try something like
zLowerTri = tril(z);
contour(x,y,zLowerTri)
Since contour plots with the origin at lower left instead of upper right, you may prefer either
zLowerTri = tril(z);
contour(x,y,zLowerTri)
axis ij
or
contour(x,y,fliplr(tril(fliplr(z))))
  4 Comments
Pourya Alinezhad
Pourya Alinezhad on 19 Jul 2013
use "nan" as i mentioned below to make that part invisible... functions you use {ex:tril(z)} replace the data values with zero,which itself could be a data!!!
Maryam
Maryam on 19 Jul 2013
Thank you very much. I now have what I wanted.

Sign in to comment.

More Answers (1)

Pourya Alinezhad
Pourya Alinezhad on 18 Jul 2013
Edited: Pourya Alinezhad on 18 Jul 2013
hello maryam, run following lines of code.
x=0:0.1:10;
y=x;
j=1;
z=meshgrid(x,y);
h=ones(length(x),length(x))*nan;
for i=1:length(x)
for j=1:length(y)
if i>j
h(i,j)=z(i,j);
end
end
end
surf(sin(h)./sqrt(h))
figure
contourf(sin(h)./sqrt(h))

Categories

Find more on Contour Plots in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!