How to implement angular range constraints in SimMechanics 2nd Generation?
1 view (last 30 days)
Show older comments
Hi
I'm trying to use SimMechanics 2nd Gen to model a revolute joint with angular ranges of +-90 degrees.
SimMechanics has a fixed angle constraint, but I would like to move my system till it reaches the limits and only then have the constraint engage.
Can you please advise how I can do this? I've successfully implemented this using the SimScape foundation library but I cannot correctly interface this to SimMechanics. The joint goes past the angular limits.
Any help would be appreciated.
Regards
Amir
0 Comments
Answers (1)
Javaria Chiragh
on 24 May 2014
There is an Angle Constraint block in Simscape/SimMechanics/2ndgeneration/Constraints but I dont know how to use it...!!
0 Comments
See Also
Categories
Find more on Assembly in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!