hdlsetup

Set up model parameters for HDL code generation

Syntax

hdlsetup("modelname")

Description

hdlsetup("modelname") sets the parameters of the model specified by modelname to common default values for HDL code generation.

Open the model before you invoke the hdlsetup command. After using hdlsetup, you can use set_param to modify these default settings. For example:

set_param(gcs, "Solver", "VariableStepDiscrete")

See this table for the solver configuration parameters that hdlsetup configures. These parameters reside in the Solver pane of the Configuration Parameters dialog box.

Command-Line Parameter Setting	Configuration Parameter Setting
Set `Solver` to `FixedStepDiscrete`.	Set Type to `Fixed-set` and Solver to `Discrete (no continuous states)`.
Set `FixedStep` to `auto`.	Set Fixed-step size (fundamental0 sample time) to `auto`.
Set `EnableMultiTasking` to `off`.	Disable the Treat each discrete rate as a separate task check box.
Set `AlgebraicLoopMsg` to `error`	Set Algebraic loop to `error`.
Set `ShowLineDimensions` to `on`.	Set Single task data transfer to `error`.
Set `ShowPortDataTypes` to `on`.	Set Multitask data transfer to `error`.
Set `BlockReduction` to `off`	Disable the Block Reduction check box.
Set `ConditionallyExecuteInputs` to `off`.	Disable Conditional input branch execution.
Set `DefaultParameterBehaviour` to `Inlined`. You can set this parameter at the command line by using `set_param` or `hdlsetup`.	Set Default parameter behavior to `Inlined`. If you want to set this parameter in the Configuration Parameters dialog box, you must have Simulink^® Coder™. Note Enabling this parameter is the same as setting the `InlineParams` property to `on`. Setting `InlineParams` to `off` changes `DefaultParameterBehavior` value to `Tunable`.
Set `DataTypeOverride` to `off`.	No dialog box prompt.
Set `ProdHWDeviceType` to `ASIC/FPGA->ASIC/FPGA`.	Set Device vendor to `ASIC/FPGA`.
Set `ShowLineDimensions` and `ShowPortDataTypes` to `on`.	In the Debug tab, on the Information Overlays, select Base data types and Signal Dimensions.
Set `SampleTimeColors` to `on`.	In the Simulink Editor, in the Debug tab, select Information Overlays > Colors.
Set `SignalLoggingSaveFormat` to `Dataset`.	No dialog box prompt.
Set `WideLines` to `on`.	No dialog box prompt.
Set `HideAutomaticsNmaes` to `off`.	No dialog box prompt.

If there are incompatible model parameters, HDL Coder™ displays a warning and lists the model parameters that have to be fixed.

Version History

Introduced in R2006b