Main Content

Standalone Target Computer Setup

Real-time application configuration to be independent of MATLAB®

You can create a real-time application that runs standalone on a target computer, without a development computer running MATLAB. Configure the standalone application so that it starts running when the target computer starts. The application continues for as long as the target computer is operating.

To start and stop the standalone application, tune parameters, and view signal values, use Simulink® Real-Time™ Explorer or use the target computer command-line interface.

Tools

Simulink Real-Time ExplorerInteract with target computer and real-time application running on target computer
Simulink Real-Time TET MonitorMonitor task execution time for the real-time application running on target computer

Functions

slrtExplorerOpen Simulink Real-Time explorer and interact with target computers and real-time applications
slrtTETMonitorOpen Simulink Real-Time task execution time (TET) monitor

Topics

Real-Time Application and Target Computer Modes

Run real-time applications by using the target computer in connected mode, standalone mode, or external mode. Speedgoat target machines boot the QNX® Neutrino® RTOS and then you run real-time applications in the selected target computer mode.