Main Content

XCP CAN FD Transport Layer

Transport XCP messages via CAN FD

Since R2022b

  • XCP CAN FD Transport Layer block

Libraries:
Vehicle Network Toolbox / XCP Communication / CAN FD

Description

The XCP CAN FD Transport Layer subsystem uses the specified device to transport and receive XCP messages.

Use this block with an XCP CAN FD Data Acquisition block to acquire and analyze specific XCP messages. Use this block with an XCP CAN FD Data Stimulation block to send specific information to modules.

Other Supported Features

The XCP communication blocks support the use of Simulink® accelerator and rapid accelerator modes. Using this feature, you can speed up the execution of Simulink models. For more information on this feature, see Acceleration (Simulink).

Parameters

expand all

The CAN device, chosen from all connected CAN devices.

Simulation refresh rate, specified as the sampling time of the block during simulation. This value defines the frequency at which the XCP CAN FD Transport Layer subsystem and the underlying blocks run during simulation. For information about simulation sample timing, see Timing in Hardware Interface Models. If the block is inside a triggered subsystem or inherits a sample time, specify a value of -1. You can also specify a MATLAB® variable for sample time. The default value is 0.01 simulation seconds.

Extended Capabilities

Version History

Introduced in R2022b