How can I change the max baudrate at c2000 sci setup host

Hi,

I'm trying to do a PIL-Simulation with Matlab. I use the eZdsp TMS320F28335 evaluationboard with CCSv5.1 and Matlab 2013b. I connect with my Board via SCI-A and use the Host SCI Blocks to set the configurations for the connection (baudrate, parity mode etc.). If I start the PIL-Simulation everything works fine but it's realy slow, because I can only choose between 110 an 115200 baud.

Is it possible to set the max. baudrate of this block to 1000000 Baud by changing the.m-file?

Thanks!

Bene