How to Reduce the time of capturing image
3 views (last 30 days)
Show older comments
Here is my code for capturing image
vid=videoinput('winvideo',1);
vid.Framespertrigger=1;
start(vid)
im=getdata(vid);
imagename=('C:\Program Files\MATLAB\R2013a\bin\test.tif');
imwrite(im,imagename);
stop(vid);
This code is taking around 2 seconds to capture one image,but the camera frame rate specifies it is 15 frames/sec,Is it possible to capture 15 images per second or even close to it? If so what modification I should make in this code, Please help me..Thank you
0 Comments
Accepted Answer
Image Analyst
on 8 Nov 2014
Use "run and time" to see where the time is being spent. I bet most of it is in calling videoinput() - that takes a long time. imwrite() also takes a long time. To speed up you can use a ramdisk or use solid state drives instead of hard drives.
0 Comments
More Answers (1)
Anchit Dhar
on 13 Nov 2014
Edited: Anchit Dhar
on 13 Nov 2014
Starting/Initializing the camera takes up some time. Starting/Stopping for each frame can slow down your application considerably. In order to capture frames at a higher frame rate, you can start the camera once and then use 'manual triggering' to grab the frames in a loop. The following example describes this method.
As an alternate solution, you can use the WEBCAM interface (introduced in R2014a).
0 Comments
See Also
Categories
Find more on Image Acquisition Support Packages for Hardware Adaptors (Generic Video Interface) in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!