How can I use multimeter in the sequential circuit design with Xor gate and measure power in microwatts?
1 view (last 30 days)
Show older comments
I am designing a sequential circuit using XOR gate in matlab2014 but when I ran the following errors occurs:
1. Invalid setting for input port dimensions of 'AHpower/Demux'. The dimensions are being set to [-1]. This is not valid because the total number of input and output elements are not the same. Component: Simulink | Category: Block error
2. Error in port widths or dimensions. Invalid dimension has been specified for output port 1 of 'AHpower/Multimeter'. Component: Simulink | Category: Block error How can I solve these errors?
1 Comment
Joel Van Sickel
on 13 Oct 2023
can you share your model? It probably has to do with how the multi-meter is set up and I can't tell just from the screenshot.
Answers (0)
Communities
More Answers in the Power Electronics Control
See Also
Categories
Find more on Simscape Electrical in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!