State Flow Error - occurs when trying to run

Hello,

I am trying to get stateflow to run I get the model error from an unknown source reported by simulink "Error using ===> create_file_name info at 267 unexpected compiler".

How would I correct this error?

[Kaustubha Govind]

Try running "mex -setup" and run the model again. Note that you need to have a supported compiler installed. Look at the list on the following page corresponding to your version and platform: http://www.mathworks.com/support/compilers/previous_releases.html

[Fabian]

Had the same problem

Thank you Kaustubha for the help

Answer 1

[Andreas Goser]

Along the lines of Kaustubha's comment. The most frequent failure mode is, that users do not know that

1. Stateflow always needed a C Compiler, but the LCC Compiler came within a Win32 installation
2. There is no C Compiler installed with Win64 MATLABs
3. BUT: There is always a supported free of charge MSVC Express edition compiler

Also interesting: Preparing for 64 Bit