Hello, how do I feed the output of the input selector to the buck-boost converter using Simulink modeling?

 Accepted Answer

Hi Danikha, 
As per my understanding, you are generating a signal from input selector and you intend to utilize this signal as voltage source for the Buck-Boost Converter circuit.
Besides, upon reviewing the attached model, I have understood that the circuit was designed using components from the “Simscape / Electrical / Specialized Power Systems” library.  
In this case, to connect the Simulink signal to the circuit, I would suggest utilizing the “Controlled Voltage Source” block as shown in the figure below:
 
For more information, please refer to the below attached MathWorks Documentation link on “Controlled Voltage Source” block:  https://www.mathworks.com/help/sps/powersys/ref/controlledvoltagesource.html  
Hope this help! 
Regards, 
Aishwarya 

More Answers (0)

Categories

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!