Wind Turbine Doubly-Fed Induction Generator

Error:Invalid setting in 'WindFarmInductionGenerators/Wind Farm/Wind Turbine Protections/Protection System1/AC Current Protection/Current Measurement/Gain2' for parameter 'Gain'.

Caused by:

The parameter supports only finite values.

Answer 1

[Umar]

Hi @Arun Prakash,

After reviewing your comments, you can resolve the error regarding the 'Gain' parameter in your Simulink model by making sure that the gain value is set to a finite number. Here are the steps to troubleshoot and fix the issue:

Check Gain Value: Navigate to the block at the specified path (WindFarmInductionGenerators/Wind Farm/Wind Turbine Protections/Protection System1/AC Current Protection/Current Measurement/Gain2) and verify the value assigned to the Gain parameter. Ensure it is a finite number (e.g., 1, 2.5, -3).

Parameter Initialization: If the gain value is being set programmatically or through a variable, ensure that the variable is initialized correctly and does not result in non-finite values.

Simulink Diagnostics: Utilize Simulink's diagnostic tools to identify any other potential issues in the model that may affect the gain setting.

Rebuild the Model: If the problem persists, consider rebuilding the block or the entire model to eliminate any hidden configuration issues.

By following these steps, you should be able to rectify the error and ensure that the gain parameter is set correctly.

Hope this helps.

[Arun Prakash]

This is an example model. Its working in other computer and not working in mine. I followed the steps however its not working. Thank you for your effort.

[Umar]

Hi @Arun Prakash,

Thanks for clarifying since this was not mentioned in your original posted comments. It may be beneficial to compare the configurations of both computers to identify any discrepancies. Hope this helps!