Battery Pack Modeling using Battery Builder AppPack Modeling(5/5) Exploring the Custom Battery Pack Block

I have been trying to submit this particular task : "You will use the Data Inspector to observe the voltage of each cell in the battery pack.

TASKRight-click the batteryVoltage port of the Battery Pack and select Log Selected Signals to observe the cell voltage.

Change the Stop Time in the Simulate section to 200. Go to the Simulation tab and click Run to simulate the model.

In the Review Results section, click Data Inspector. The Simulation Data Inspector window pops up. In the Inspect Pane, click NewPack:3 (8). A dialog box Multidimensional Signal appears. Select Convert to channels (8). Select NewPack:3(1) and NewPack:3(8).

Did you observe that both the voltages are same?"

I am able to see that the voltages are the same, but when I submit the simulation again runs and the data inspector shows other signals that are not selected as well, so when the matlab platform runs the check it delivers that the task is not done. I have attached some screenshots for reference. how do I complete this task.

when the matlab runs again this is the result: even the unselected signals shows up in the chart. are there any settings I could try ?