Using set_param with Configuration Set Reference

I have a medium sized Simulink project using Configuration Reference to tie all the submodels (Model Reference) to one Configuration set. Is there a way to change the configuration parameters from the command line using set_param? I get the error:

A configuration set reference does not allow writing to parameters in the source configuration set

Answer 1

[Tiago Grossinho]

Hello,

You probably have your question answered 1 year later, but for reference, I found my answer in the following page:

https://fr.mathworks.com/help/simulink/ug/configuration-set-api.html

Chapter " §Change Values in a Referenced Configuration Set". Indeed, if you " Get" the config set which corresponds to the active one in your model, the set_param operation will immediately set the value in the model. My example:

>> get_param('model_name','RTWCAPISignals')

ans =

on

>> cref=getConfigSet('model_name','Reference');
>> cset = cref.getRefConfigSet;
>> set_param(cset,'RTWCAPISignals','off');
>> get_param('model_name','RTWCAPISignals')

ans =

off

Hoping it may help someone in the future, or even myself when I forget it one day! :)

[Gergely Takacs]

Thank you for the tip. Not entirely user friendly to figure this out:)

[Krishna Akella]

Thanks, it helped me today!