MATLAB Answers

How to set up Altera Cyclone V SoC Development Kit for Embedded Coder Support Package?

2 views (last 30 days)
Netanel
Netanel on 30 Nov 2016
Commented: Netanel on 11 Dec 2016
I have performed steps successfully until step 9 -connect the hardware
but matlab unable to connect the device using JTAG (time-out error) how i need to setup the hardware? how to config the different jumpers on the board?
Netanel
  2 Comments
Netanel
Netanel on 11 Dec 2016
Sorry you are rigth... my corrected question is:
I have performed steps successfully until step 9 -connect the hardware
https://www.mathworks.com/help/supportpkg/alterasocembeddedcoder/ug/installation-and-setup.html
but matlab unable to connect the device using USB-to-UART(time-out error) how i need to setup the hardware? how to config the different jumpers on the board?
Netanel

Sign in to comment.

Answers (1)

Wang Chen
Wang Chen on 8 Dec 2016
Edited: Wang Chen on 8 Dec 2016
Hi Netanel,
Do you mean the serial connection (USB UART) is timing out?
Please set the jumper setting the same as the picture in page 12 of the board User Guide. Please make sure J28, J29, J30 is set the same as the picture.
https://www.altera.com/content/dam/altera-www/global/en_US/pdfs/literature/ug/ug_cv_soc_dev_kit.pdf
  1 Comment
Netanel
Netanel on 11 Dec 2016
Thank Wang!
I have done all this, yet it did'nt work until
  1. unplug the usb cable from USB-to-UART
  2. plug usb cable to the USB Blaster on the board
  3. verify that windows identify the USB Blaster driver(need to be install part of DS-5)
  4. finally re-plug the usb cable to USB-to-UART
i know it sounds not logic but in my case this is the only thing i try and it works! maybe i wrong, but i suggest others that come up with the same issue to try it...

Sign in to comment.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!