Difference between Phasor Simulation and Load Flow
2 views (last 30 days)
Show older comments
I am modeling two area power system in Simulink for which I am able to successfully run load/power flow using Powergui - Load Flow Tab. But when I run the Phasor simulation of the model it throws error as:
"There is no voltage source, current source, or machine block with a frequency matching the Phasor simulation frequency."
In the two area system there are only generators, loads, lines and shunts. I am trying to understand the difference between load flow and Phasor Simulation?
0 Comments
Answers (1)
Sudarshan Kolar
on 8 May 2017
Hello Puneet,
I understand that you want to understand more about phasor simulation. I have pulled up some docs that might help you:
2. http://www.mathworks.com/help/physmod/sps/powersys/ug/introducing-the-phasor-simulation-method.html 3. https://www.mathworks.com/help/physmod/sps/powersys/ug/_f12-6010.html
(Please refer to examples in the above link).
4. This explains the difference: https://electronics.stackexchange.com/questions/167533/phasor-simulation-versus-power-flow
5. I found a webinar as well:
Hope that helps.
Sudarshan
0 Comments
See Also
Categories
Find more on Switches and Breakers in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!