Plot multiple Surfaces to Axes in GUI?

Hello.

I am trying to plot 6 surfaces that create a cube to an axes within a GUI but cannot figure out how.

Any advice on how to go about doing this?

Attached is a photo of the cube plot in a figure.

Below is the code I use for producing the figure. I just need that figure to go into the GUI axes.

Thanks,

Nicholas

hold on
sA = surf(mg1, mg2, z1, fMat{1}', 'FaceColor', 'texturemap','LineWidth',3);
sB = surf(xn1, mg2, mg1,fMat{2}', 'FaceColor', 'texturemap','LineWidth',3);
sC = surf(mg1, mg2, zn1,fliplr(fMat{3}'), 'FaceColor', 'texturemap','LineWidth',3);
sD = surf(x1, mg1, mg2, flipud(fMat{4}), 'FaceColor', 'texturemap','LineWidth',3);
sE = surf(mg1, yn1, mg2,flipud(fMat{5}), 'FaceColor', 'texturemap','LineWidth',3);
sF = surf(mg1, y1, mg2, fliplr(flipud(fMat{6})), 'FaceColor', 'texturemap','LineWidth',3);

Answer 1

[Adam]

doc surf

There is a syntax for surf as:

surf( ax,... )

which allows you to pass in an axes handle as the first argument, then everything else after it exactly as you have it now.

Also

hold( ax, 'on' )

will hold this axes on. Just pass in the handle to the axes in your GUI.

You should get used to always using this syntax with an explicit axes handle.