Update internal mechanics parameters of Simmechanics Revolute joint while simulation is in progress

1 view (last 30 days)

Show older comments

Leslie Castelino on 16 Jun 2017

0
Link

Direct link to this question

https://in.mathworks.com/matlabcentral/answers/345076-update-internal-mechanics-parameters-of-simmechanics-revolute-joint-while-simulation-is-in-progress

Commented: Sanil Mhatre on 4 Aug 2017

How do I keep updating the value of spring stiffness and damping coeff. in a Revolute joint (Simmechanics 2nd generation) while the simulation is running? For eg. Stiffness from 1-5 sec of simulation time is 10 Nm/rad and from 6-10 sec it is 20 Nm/rad.

1 Comment
Show -1 older commentsHide -1 older comments

Sanil Mhatre on 4 Aug 2017

I have come across a similar issue. Please update if a solution is found.

Sign in to comment.

Sign in to answer this question.

Answers (1)

Sagar Doshi on 20 Jun 2017

0
Link

Direct link to this answer

https://in.mathworks.com/matlabcentral/answers/345076-update-internal-mechanics-parameters-of-simmechanics-revolute-joint-while-simulation-is-in-progress#answer_271333

I don't think it is possible. You cannot tune most Simscape Multibody block parameters during simulation. This doc link might be helpful.

0 Comments
Show -2 older commentsHide -2 older comments

Sign in to comment.

Sign in to answer this question.

Categories

Physical Modeling Simscape Multibody Multibody Modeling Multibody Dynamics

Find more on Multibody Dynamics in Help Center and File Exchange

Tags

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!