How can I repeat the code for multiple timesteps?
1 view (last 30 days)
Show older comments
Danny Helwegen
on 26 Nov 2018
Commented: Walter Roberson
on 26 Nov 2018
Hi, I need to write a code to let a particle move multiple timesteps, where the timesteps can be any number (e.g. 2 or 50). The situation is the following, I have an array where a x-coordinate, an y-coordinate and the direction are in:
Q =
1 2 1
1 3 1
3 3 2
3 1 1
2 3 2
To make it easy, x and y can be 1, 2 or 3 and the direction can be 1 or 2. The direction I have defined as:
if Direction == 1 %If the direction ==1 then x stays equal but y becomes 1 higher
x = x
y = y + 1
end
if Direction == 2 %If the direction ==2 then y stays equal but x becomes 1 higher
x = x + 1
y = y
end
But how can i let this repeat for multiple time steps, because, like the code above is now, this should happen in one timestep where this timestep (dt) is set.
0 Comments
Accepted Answer
Walter Roberson
on 26 Nov 2018
for stepnum = 1 : 100
.... your existing lines
end
2 Comments
Walter Roberson
on 26 Nov 2018
It is a for loop. for acts like a repeated assignment statement.
You can use whatever variable name is convenient for your purposes. For example,
for timestep_number = 1 : 100
... your existing lines
end
You could also use
for time = 0 : 0.01 : 5
.... your existing lines
end
but in practice it is usually easier to iterate over step numbers than to iterate over times if you need to record data as you go along.
More Answers (0)
See Also
Categories
Find more on Logical in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!