TMS320F28335: Model for Simulink based buck converter control
11 views (last 30 days)
Show older comments
I have been trying to implement the logic that I used in my simulations using F28335. But I am having difficulties using the encoder blocks.
Control logic I am trying to develop:
Generate error signal from comparing the values across two ADC inputs (reference and feedback) if the error is positive (i.e. reference > feedback) increase the duty cycle of ePWM output else decrease the duty cycle of ePWM.
Also, if I use the ADC block and attach a scope and run the simulation after transferring the code to hardware, I cannot view the converted value by the ADC (I am varying the voltage across the ADC pins betwwen 0-3V but the scope always reads 0).
Can someone please guide me through using the Simulink?
0 Comments
Answers (2)
Venkatesh Chilapur
on 13 Feb 2019
Hi,
Please let us know if this example works for you.
The example would use the ADC and PWM module.
Regards,
Venkatesh C
0 Comments
Antonin
on 13 Feb 2019
Hi Priyanka,
Are you trying to run "Peak current control"? Let us know,
Thanks,
Antonin.
1 Comment
mehdi goudarzi
on 29 Jun 2022
hi antonin
i tried to run peak current control but f28335 get me an error for using rs flip flop
can you help me
thanks
mehdi
See Also
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!