How can I read data via SCI and display it in Simulink?

Hello again,

I am using the TMS570LS0432 MCU from Texas instruments and I would like to view my results of the working programm with simulink.

In the programm I am displaying data via the SCI-interface in the terminal. Instead of this i would like to visualize it in Simulink also with the SCI.

I have already downloaded the embedded coder and the c2000 processor support packages for simulink, but i actually don't know how to set this up with simulink.

I have several different datatypes (8x Byte and ~45 Bit) i am transferring via the SCI in a loop. And therefore I already don't know how I should setup this receive block and then how to display the data.

Do you have some advice or a tutorial? I actually just want to read the SCI and, if possible, don't want to generate code with the embedded coder, so I don't have to change my programm...

Kind regards

Christian

Answer 1

[Venkatesh Chilapur]

Hi,

Please checkout the 2 model approach at page:

https://in.mathworks.com/help/supportpkg/texasinstrumentsc2000/examples/permanent-magnet-synchronous-motor-field-oriented-control.html

section: Fast Serial Data Monitoring

Regards,

Venkatesh C