Hi. I want to do a predictive maintenance system with Matlab but I don't have enough bearings data. Do you know hot to generate run-to-failure data in Matlab ? I don't care about bearings type or parameters ?
A digital twin can enable you to generate additional bearing data with some knowledge of your bearings. For an introduction, please read the paper by Steve Miller on Predictive Maintenance using a Digital Twin:
To dive deeper, you can take a look at the eBook linked below which refers to additional resources. Since you have limited data, you are probably going for a physics-based or combined physics and data-based. For this, Simulink and Simscape can handle solver behavior and physics equations to help you produce failure data for thousands of component lifetimes