MATLAB Answers

How to "Monitor and Tune" Simulink Model from MATLAB

8 views (last 30 days)
I have a Simulink model that controls a DC motor's position. The angular position for the motor to rotate to comes from a constant block, which I write to in a Matlab script using set_param. I've seen how set_param('modelName', 'SimulationCommand', 'start') can be used to start a simulation within Simulink, but is there a similar command to run the model [on hardware] in the "Monitor and Tune" mode?
I want to run the model on the hardware connected to my PC (Arduino Mega), but at certain points in the script, I need the motor to move to a different position. Thus, I still need to be able to write to the model using set_param, so I cannot just build and deploy the model to hardware.
Any advice is appreciated.

Accepted Answer

Chaitanya Mallela
Chaitanya Mallela on 26 Nov 2020
You can try out this command for Monitor and Tune mode
set_param(gcs, 'SimulationMode', 'external')

More Answers (0)




Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!