How to enable the signal visualization blocks in the "QPSK Receiver with ADALM-PLUTO Radio" example?
2 views (last 30 days)
Show older comments
MathWorks Support Team
on 15 Dec 2020
Edited: MathWorks Support Team
on 18 Apr 2024
I am trying to use the signal visualization blocks found in the following example (QPSK Receiver with ADALM-PLUTO Radio):
However, I can not find a way to activate these signal visualization blocks as the process to do so is not mentioned in the example documentation.
I had noticed that one sentence in the doc says, "To ensure real-time processing, the model is by default set to run in Accelerator mode, and to remove all signal visualization", but when I tried running the model in Normal mode there was no change. How do I activate these blocks?
Accepted Answer
MathWorks Support Team
on 18 Apr 2024
Edited: MathWorks Support Team
on 22 Dec 2021
In the example model, if you double click on the QPSK receiver block, you will see the spectrum analyzer and constellation diagram blocks (4 blocks in total) as shown below.
Please right-click on each of these blocks and select 'Uncomment'. Uncommenting all these four blocks should show you the visualizations.
0 Comments
More Answers (0)
See Also
Categories
Find more on RF Component Modeling in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!