How can I plug inverse kinematics to a Simscape multibody?
6 views (last 30 days)
Show older comments
Hello,
This is my Simulink model of a delta robot using Simscape multibody. I have an inverse kinematics matlab code. How can I plug it into the Simulink model?
0 Comments
Answers (1)
Juan Sagarduy
on 26 Apr 2021
Hello there
You need to set the joint in kinematic mode (Actuation >> Motion - Prescribed / Torque - automatically calculated) See below.. Then feed the joints with a time-dependent trace matching the duty cycle you expect the mechanism to execute. See that a little arrow pops up so that the signal can be connected.
Best of Luck / Juan
See Also
Categories
Find more on Multibody Modeling in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!