photo

Sam


Last seen: 10 months ago |  Active since 2019

Followers: 0   Following: 0

Statistics

  • Thankful Level 2
  • Explorer
  • First Review
  • Thankful Level 1

View badges

Feeds

View by

Question


battery(tabled based) doesn't work properly
I specified the peramerter properly in the mask of this block, but when i ran the model, it poped out an ERROR: Error compiling...

4 years ago | 0 answers | 0

0

answers

Question


Where to find the generated simscape code
Hi does anyone know where to find the generated simscape code? I simply built a dummy model down below and then used simulink co...

4 years ago | 1 answer | 0

1

answer

Question


Xilinx system generator 2019.2 configured with matlab 2018b blocks do not show up!!!
The Xilinx system generator 2019.2 configured with matlab 2018b with no problem, and the xilinx blockset also apear in the simul...

4 years ago | 0 answers | 0

0

answers

Answered
How to specifiy the parameters of "Distributed Parameter line" block?
Hi Sayed, I've already added your through facebook

5 years ago | 0

Question


Decimal point disappear when i use matlab read xlsx file. Is there anyone know how to solve this problem?

5 years ago | 0 answers | 0

0

answers

Question


How can i add simscape block programmatically
I konw how to add the basic simulink block programmatically. But when i use the same method, there is always something went wron...

5 years ago | 1 answer | 0

1

answer

Question


how to solve Index exceeds the number of array elements (1).
Hi guys, I'm writing a code for simulink model auto generation . But when i run code, it popup this error . How can i solve this...

5 years ago | 1 answer | 0

1

answer

Question


Is there a way to build a model like this lt spice model with simscape ?
with ltspice a single statement can already make two ramdom inductor coupled with each other. Is there way to make two random in...

5 years ago | 1 answer | 0

1

answer

Question


How to specifiy the parameters of "Distributed Parameter line" block?
I want to use the "Distributed Parameter line" block to simulatiing voltage at the electric motor terminal. According to the doc...

5 years ago | 4 answers | 0

4

answers

Question


How can i build a 3 phase inverter with simscape, which the output voltage with rise and fall time?
How can i build a 3 phase inverter with simscape, which the output voltage with rise and fall time? Normally the IGBT block ar...

5 years ago | 1 answer | 0

1

answer

Question


How can i make the simulink block to show a float window, which contains the parameter configuaration of the block, when i put my mouse on the block?

5 years ago | 1 answer | 0

1

answer