Community Profile

photo

Kranti Balaga

Last seen: 12 days ago |  Active since 2021

Statistics

  • Knowledgeable Level 1
  • Revival Level 2
  • First Answer

View badges

Content Feed

View by

Answered
HDL QPSK Transmitter and Receiver CFO problem
Yes, simply you can provide the Symbol rate in the Inputdata mask, change the Carrier Frequency Offset (in Hz) corresponding to...

28 days ago | 0

Answered
HDL QPSK Transmitter and Receiver CFO problem
Hi Ali Shan, I am fine, hope you are doing well. The more average length gives a better/accurate estimate, but that d...

29 days ago | 0

Answered
HDL QPSK Transmitter and Receiver CFO problem
Hi Ali Shan, The value 0.125 implied in the algorithm that we choose. Implemented correlation based estimation, as the r...

1 month ago | 0

Answered
HDL QPSK Transmitter and Receiver CFO problem
Hi Ali Shan, In QPSK single carrier model, the carrier frequency estimates in steps of coarse and fine estimates which a...

2 months ago | 0

| accepted

Answered
Modifying the QPSK RX for TDD for hw/sw design in ad9361
Hi Muhammad, The Model you are referring is not supported for discrete valid of inputs, and the receiver is expecting alw...

9 months ago | 0

Answered
HDL optimized QPSK TX and RX combined
Hi, There are some limitations in the model due to receiver architecture. Here, Timing recovery would be self synchronizin...

1 year ago | 0

Answered
Addition of signals in simulink
Hi, To demodulate the I and Q signals without using QPSK demodulator block can be done for the hard decision. You can get I...

1 year ago | 0